Chapter 5 Appendix
101
Chapter 5 Appendix
Chapter 5 Appendix
5-7 Specifications
Main Specifications
DWX-30
Cuttable material
Zirconia (pre-sintered), modeling wax
Loadable workpiece
shape
Disc (with levels)
External diameter (level section) : 98 to 100 mm
External diameter (body section) : 95 mm
Height (level section) : 10 mm
Height (body section) : 12 to 26 mm
Disc (without levels)
External diameter : 98 to 100 mm
Height : 10 to 14 mm
Block
Width x Depth : 40 x 75 mm, Height : 12 to 26 mm
X, Y, and Z operation
strokes
X, Y, and Z: 239 x 205 x 100 mm (9.4 x 8.1 x 3.9 in.)
Maximum angle of
rotation
±18×105° (±5000 rotations)
X-, Y-, and Z-axis drive
system
Stepping motor
Operating speed
X and Y axes: 0.1 to 60 mm/sec. (0.004 to 2.4 in./sec.)
Z axis: 0.1to 30 mm/sec. (0.004 to 1.2 in./sec.)
A axis: 11.25rpm
Software resolution
X, Y and Z axis: 0.01mm/step (0.0004 in./step,) A axis: 0.0225°/step
Mechanical resolution
X and Y axis: 0.00125 mm/step (0.00005in./step) (micro-step control)
Z axis: 0.00125 mm/step (0.00005in./step) (micro-step control)
A axis: 0.0028125° /step (micro-step control)
Spindle motor
Brushless DC motor, maximum 100W
Spindle speed
6,000 to 30,000 rpm
Tool chuck
Collet method
Interface
USB (compliant with Universal Serial Bus Specification Revision 1.1)
Control command set
RML-1
Required power-sup-
ply amperage
Voltage and frequency: AC 100 to 120 V/220 to 240 V ±10%, 50/60 Hz (overvoltage
category II, IEC 60664-1)
Required power capacity: 2.8 A (100 to 120 V)/ 1.2 A (220 to 240 V)
Power consumption
275 W
Operating noise
During operation: 60 dB (A) or less (when not cutting), during standby: 40 dB (A)
or less
External dimensions
Width x Depth x Height: 606 x 656 x 557 mm (23.9 x 25.9 x 22 in.)
Weight
47 kg (104 lb)
Installation Environ-
ment
Operating environment: Temperature of 5 to 40°C (41 to 104 °F), 35 to 80% relative
humidity (no condensation)
Ambient pollution degree: 2 (as specified by IEC 60664-1)
Included items
Power cord, handy panel, collet (diameter 3.175 mm, 4.0 mm, 3.0 mm), detection
pin, cap*, spacer, clamp for block workpiece, hexagonal driver, hexagonal wrench,
spanner (10 mm, 17 mm), dust tray, USB cable, User’s Manual (this document), Roland
Software Package CD-ROM, etc.
* The cutting machine is shipped from the factory with the cap installed on it.
