6
Panel Descriptions
Front
fig.
Rear
fig.
1 Digital Input
Coaxial Input Connector (Digital Input)
This is the digital input connector for coaxial cable.
It cannot be used for input of analog audio signals (no sound
is produced).
Optical Input Connector (Digital Input)
This is the digital input connector for optic-fiber cable. Use
commercially available optical cable for audio equipment to
make the connection.
Optical-connector Protective Cap
• After removing the protective cap, put in a safe place so
that it doesn’t get lost.
• When not using the optical connector, attach the cap to
keep the connector safe.
• When using the optical connector, be sure that the cap
you removed is placed out of the reach of children. If a
child has accidentally swallowed a cap, see a doctor
immediately.
Bass-reflex Ducts
These are conduits
for rich, bass-range reproduction.
Power Switch
This switch turns the power on/off.
Power Indicator
Lights when power is on.
HF Driver
* Do not touch the diaphragm.
LF Driver
* Do not touch the speaker cone.
Before turning the power on or off, you
must lower the volume of this unit and
your connected device etc.
This unit is equipped with a protection
circuit. A brief interval (a few seconds)
after power up is required before the unit
will operate normally.
Digital In Indicator
This lights
up when output is received from a
connected digital device or during standby.
Connect the digital-signal output device, set the
"Input Select switch" to DIGITAL INPUT, and set
the "Digital Input select switch" according to the
connector to which the device is attached (Coaxial
or Optical).
* When the connected digital-signal output device
is not powered up, the Digital In indicator does not
light up.
Power cord
5
4
3
2
6
7
8
1
Summary of Contents for DS-30A
Page 12: ...02901001 2RCC...
