Roland DP90e, Owner'S Manual

Page: 13 / 68

Before You Play
Turning the Power On/Off
Once everything is properly connected (p. 11), be sure to follow the
procedure below to turn on their power. If you turn on equipment
in the wrong order, you risk causing malfunction or equipment
failure.
NOTE
Before turning the unit on/off, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/off. However, this is normal
and does not indicate a malfunction.
On
Off
1
3
2
Min Max
Turning the power on
1.
Move the [Volume] slider all the way to the left to
minimize the volume .
2.
Press the [Power] switch .
After a brief interval, you’ll be able to produce sounds by playing
the keyboard.
* This unit is equipped with a protection circuit. A brief interval (a
few seconds) after turning the unit on is required before it will
operate normally.
3.
Use the [Volume] slider to adjust the volume .
Adjust the volume while playing something on the keyboard, so
you can hear how it sounds.
This will adjust the volume of the speakers if you’re using
the speakers of the unit, or the volume of the headphones if
headphones are connected. Each volume setting (for speaker or
headphone) is saved automatically.
Volume adjustment screen
when using speakers
Volume adjustment screen
when using headphones
MEMO
The unit is designed so that nuances in the dynamics of your
playing will be clearly heard even at low volume, and that the
sound will remain clear even at high volume.
Turning the power off
1.
Move the [Volume] slider all the way to the left to
minimize the volume .
2.
Press the [Power] switch .
The power is turned off.
If you don’t want the power to turn off
automatically, change the “Auto Off” setting to
“OFF”!
The power to this unit will be turned off automatically
after a predetermined amount of time has passed since
it was last used for playing music, or its buttons or
controls were operated (Auto Off function).
If you do not want the power to be turned off automatically,
disengage the Auto Off function (p. 39).
NOTE
• Any settings that you are in the process of editing will
be lost when the power is turned off. If you have any
settings that you want to keep, you should refer to
“Retaining the Settings Even After Power-off (Memory
Backup)” (p. 39) and save your settings.
• To restore power, turn the power on again (p. 13).
• When turning the power on again, you must allow at
least five seconds after power-off before you once again
turn the power on. If you fail to allow enough time, the
Auto Off function might not be reset, preventing the
power from turning on correctly.
13
O
per
ation G
uide
Panel Descriptions
Bef
or
e
You P
la
y
Per
forming
Pr
ac
ticing
Con
venien
t F
unc
tions
A
ppendix
Func
tion M
ode