Roland DP603, Owner'S Manual

Page: 18 / 34

16
Advanced Operation
˙ Saving Your Performance Settings (Registration)
Tone settings and settings such as Dual Play or Split Play can be
saved and recalled easily.
Such settings are called a “registration.”
You can save a total of 25 registrations, five each in buttons [1]–[5].
These 25 registrations are collectively called a “registration set.”
=
Registration set
25 registrations
1-1 2-1 3-1 4-1 5-1
1-5 2-5 3-5 4-5 5-5
Settings that are saved in a registration
Setting Page
Ambience p. 8
Rotary Speed p. 8
Key Touch p. 8
Transpose p. 8
The selected tone (including Split or Dual tones) p. 8
Split on/off p. 9
Split point p. 9
Left Shift p. 9
Dual on/off p. 9
Tone 2 Shift p. 9
Balance (Split, Dual) p. 9
Twin Piano on/off p. 9
Twin Piano Mode p. 9
Damper Pedal Part p. 21
Center Pedal p. 21
Left Pedal p. 21
MIDI Transmit Ch p. 22
Recalling a Registration
1.
Press the [Registration] button.
2.
Press a number button ([1] to [5]) to choose the location
where the desired registration is saved.
3.
Press the [–] [+] buttons to select the registration variation.
The settings change accordingly.
You can press the [
J
] button to edit the selected registration.
MEMO
5
You can also use a pedal to recall registrations (p. 21).
5
If you press the [Registration] button to exit the Registration
screen, you will return to the state prior to recalling the
registration.
Saving Current Settings into a Registration
NOTE
When you save a registration into a location, it will overwrite any
registration already stored at that location.
1.
While holding down the [Registration] button, press a
button from [1] to [5] to select a registration and then press
the [–] [+] buttons to select a registration variation.
2.
Rename the registration.
[ K ] [ J ] buttons
Select the position at which you want to change
the character.
[–] [+] buttons Change the character.
If you decide to cancel, press the [
u
] (Exit) button.
3.
Press the [
s
] (Enter) button.
The registration is saved.
NOTE
Never turn off the power while the screen indicates “Executing...”