14
Oct. 2016
AE-10
Installing the Rubber Switch and Center
Panel
1.
Place a support with a certain height beneath the body, and install the
Rubber Switch.
The Rubber Switch has a hole that is used for determining the position.
Confirm that all the Boss on the Top Case are inserted to the Rubber
Switch holes.
fig.kumitate-19.eps
2.
With the support, install the Center Panel board to the Top Case.
fig.kumitate-1
8
.eps
Installing the Rubber Cap and Tube
Silicone
1.
Turn over the Rubber Cap.
fig.kumitate-4.eps
2.
Place the Rubber Cap to the tip of the Bottom Case, and straighten the
Tube Silicone.
fig.kumitate-5.eps
3.
Cut the Tube Silicone’s tip so that it will come to the center of the Boss.
fig.kumitate-6.eps
4.
The Tube Silicone should go through the path marked by the dashed
lines, and installed to the Bottom Case.
fig.kumitate-7-e.eps
5.
Confirm the installation of the Tube Silicone’s tip.
fig.kumitate-
8
-OK-e.eps
fig.kumitate-
8
-
N
G-e.eps
If the Tube is not touching to the Bottom Case, then slightly pull the Tube
upward.
fig.kumitate-
8
-
N
G1.eps
If the Tube’s width is less than half of the original, then gently pick the
bent portion, and then slightly pull the Tube upward.
fig.kumitate-
8
-
N
G2.eps
5 mm
Pass thro
u
gh the
Sensor Board.
OK
Be s
u
re to have the width of
the T
ub
e over half.
To
u
ching the Bottom Case.
Not OK
The T
ub
e width is
u
nder half.
Not to
u
ching the Bottom Case.
Summary of Contents for Aerophone AE-10
