Roksan Audio ltd
Caspian DX2 User Manual
CLASSIFICATION: General Use
Version 3.05
All specifications are liable to change without notice. E&OE
Page 3
ENGLISH
A
A
C
C
M
M
A
A
I
I
N
N
S
S
S
S
U
U
P
P
P
P
L
L
Y
Y
Your Caspian DX2 is set to operate from a fixed supply voltage which is marked on a label next to the mains
input plug. Before connecting the mains lead please check that your mains supply corresponds to this label as
below:
230V Products ………………………………….Voltage Range: 220V – 240V
115V Products ………………………………….Voltage Range: 100V – 120V
The mains lead supplied with this product has an IEC mains socket which plugs into the IEC connector on the
unit’s rear panel. The other end is normally attached to the appropriate mains plug for your country. In the UK
this is the standard UK13A plug.
This plug should ordinarily not be removed from the lead. If you
do
remove it, please dispose of it safely so that it
cannot be plugged into a mains socket whilst in a potentially dangerous condition. We suggest that you obtain
from your dealer a complete replacement lead.
Should you move to another area where either the mains voltage or the mains plugs are different from those as
supplied with your DX2, please contact the appointed ROKSAN distributor for assistance.
Please observe correct mains polarity at all times.
The DX2 mains fuses are located on the rear panel next to the IEC mains connector. They must only be replaced
by the fuse of the type and rating as described on the fuse rating label on the rear panel of the unit.
This product requires connection to earth (ground). The earth wire (in the UK this is colour coded green/yellow)
of the mains cable supplied with your DX2 must be connected to a suitable earthing point established for this
purpose by your electricity supply company. If you are in any doubt, consult a qualified electrician.
If the equipment is likely to be unused for some time, unplug it from the mains supply.
G
G
E
E
N
N
E
E
R
R
A
A
L
L
C
C
A
A
U
U
T
T
I
I
O
O
N
N
S
S
FCC WARNING
This equipment may generate or use Radio Frequency energy. The user may lose the right to operate this
equipment if unauthorised modifications are made.
INTERFERENCE
Properly installed, this unit should not cause harmful interference to radio communications, There is, however, no
guarantee that such interference will not occur in a specific installation. If interference arises (which you can
determine by switching the unit off and on) you could try to remedy matters by the following:
·
Re-orient or re-locate the receiving antenna
·
Increase the distance between the DX2 and receiver
·
Connect the unit to a different mains circuit from that of the receiver
·
Consult your ROKSAN appointed dealer or an experienced Radio/TV technician for help and advice
LOCATION
Your Caspian DX2 should be located in a well ventilated area and kept away from sources of heat, dust and
humidity and direct sunlight.
The DX2 may be positioned either as a free standing unit or alongside another audio/video product.
Never place the DX2 on carpet or any surface likely to hinder normal ventilation. This unit contains no user
serviceable parts.
Do Not remove any panels or attempt to service it yourself.
Unauthorised servicing will
void the warranty.
C A U T I O N S
C a s p i a n System DX2
