CONTROL PANEL
ASSEMBLY INSTRUCTIONS
Settle the four screws to the round base and attach the lower base tube (12) to the base using a
screwdriver (not supplied). Unscrew and remove the pole clamp (11) down over the adjustable and
lower base hole {13 & 14) until it is in place over the screws. Replace the pole clamp (11) and at
the same time raise the extension Pole (10). Attach the fan assembly on top of the pole and tighten
the Switch box retaining screw.
NB the extension Pole (10) can sometimes slip inside the lower base pole (12) during transit.
Remove the Rear Guard Central Fixing (5) nut. Place the rear guard (6) onto the motor housing (8)
and replace the Rear Guard Central Fixing (5) nut by screwing back on clockwise.
Take the fan blade (4) and slide it onto the motor spindle (7) ensuring that notches on the rear line
up with the splines on the shaft. Screw on the Blade Retaining Nut (3) in an anticlockwise direction.
Turn the five clips (2) around the outside edge of the front guard outwards.
Hang the front guard (1) over the top of the rear guard (6) and push the clips inwards until the
front guard is fastened to the rear guard.
BEFORE USE
•
Avoid placing fan near curtain and small corners to enjoy maximum airflow.
•
Do not handle power plugs with wet hands, to avoid risk of electric shock.
•
Fans in the process of operation, please avoid to insert hands or other objects in the functioning
of the blade.
1. Sleep mode
2. Normal mode
3. Natural mode
4. High Speed
5. Medium Speed
6. Low Speed
7. Swing Button
8. Mode Button
9. Timer
10. Speed/On Button
11. Off Button
12. Timer Light
REMOTE CONTROL
13. Swing Button
14. Timer Button
15. Speed/On Button
16.Mode Button
17.Off Button
REMOTE CONTROL
