Rohm RKX-EVK-001, User Manual

Page: 47 / 56

47/55
© 2022 ROHM Co., Ltd. No. 64UG118E Rev.002
Feb.2022
User’s Guide
4.
Open the PSoC Programmer application on your computer. Once opened, verify that Powered and Connected status messages are
displayed in the status bar – the bottom right side of the window ( Figure 81) . If not, please verify the CY8CKIT-059 Prototyping Kit is
properly plugged into the USB port.
Figure 81. PSoC Programmer GUI
If you received the Warning message “This Programmer is currently out of date”, or “The communication firmware on the kit does not
match what is installed with the release of the PSoC Programmer”, click the OK button to navigate to the Utilities tab in the PSoC
Programmer, and click the Upgrade Firmware button ( Figure 82) . When the firmware upgrade is completed, go back to the Programmer
tab, and proceed to the next step.
Figure 82. Programmer Firmware Update
5.
Next, select the firmware hex file mentioned in the step 2 by either pressing the Open Folder button ( Figure 81, number 1 ) or through the
menu (File>File Load) or by pressing the F4 key ( Figure 81 ).
6.
Next, flash the firmware on the CY8CKIT-059 Prototyping Kit by pressing the Down Arrow button ( Figure 81, number 2) or through the