Rohm BD868 0MUF-C Series, User Manual

Page: 15 / 35

15/35
User ’ s Guide
© 2022 ROHM Co., Ltd.
No. 65UG013E Rev.001
July 2022
Figure 6: Input Voltage Reference Selection via J3
To power ON the EVK set, an external power supply needs to be connected to the banana jacks (see
Figure 1 and Figure 4) that mounted on the MB. Check that the input voltage is in accordance with the range
reported in BD868x0 datasheet (please take care of the correct orientation of the inputs since no reverse
protection is foreseen on the MB).
5.3. Load Connection
Each output can be tested in light load or in full load.
An external load can be connected to the access points listed in the Table 2 according to the maximum
value, as indicated in the datasheet. As an example, the picture below shows how an electronic load should
be connected to output 3.
Figure 7: Example of electronic load connected to VO3
5.4. Board Access Points
The EVK board has many access points to ease measurements of PMIC outputs and other signals.
Below is a table that summarize them:
Access point Description