Rohde ELS 1000 S, Original Operating Instructions

Page: 92 / 138

91 / 136 - EN -
Step
Description
Remark
8 Tighten the locknut of the adjusting screw again.
⇒ Hold the screw with a second tool so that it does not
twist again, and the setting is lost.
Tool:
Spanner
9 Tighten the bolts of the bearing on the lower guide roller. Tool:
•
Spanner or socket wrench
• Allen key
10
Carry out the setting for the other bearing of the second guide
roller.
11 Check the setting of both guide rollers with the spirit level. Tool:
Spirit level
12
Check the extension and retraction of the kiln floor.
⇒ The kiln floor should move smoothly and without
great effort.
Table 14: Setting the inclination angle of the kiln floor
6.2.6. Mounting the exhaust air socket
Figure 6: Exhaust air socket
6.2.7. Mounting the controller mounting plate (only ELS 150-ELS 480 without eDrive)
Figure 7: Controller mounting plate ELS 150 - 480 without eDrive
Attach the supplied controller mounting plate to the kiln casing on
the left-hand side using the star knob screw provided.
The inclination of the controller mounting plate can be adjusted.
Applies to ELS 150-ELS 480 without eDrive.
The mounting plate can also be positioned on the right side of the
kiln, if the hinge of the kiln door is then attached on the left side.
Mount the exhaust air socket above the exhaust air flap on top of
the kiln.
The fastening material is included in the kiln's scope of delivery.
It is also possible to mount an exhaust air hose on the exhaust air
socket and to divert escaping vapours and gases into an exhaust
air system.