Rohde & Schwarz ZNB20, User Manual

Page: 704 / 1332

Command Reference
R&S
®
ZNB/ZNBT
689 User Manual 1173.9163.02 ─ 38
Error Term Description Receive Ports (S-parameter)
SCORr16 Isolation 3 (S31)
SCORr17 Load match 3 (S31)
SCORr18 Transmission tracking 3 (S13)
SCORr19 Isolation 1 (S13)
SCORr20 Load match 1 (S13)
SCORr21 Transmission tracking 1 (S13)
SCORr22 Isolation 3 (S32)
SCORr23 Load match 3 (S32)
SCORr24 Transmission tracking 3 (S32)
SCORr25 Isolation 2 (S23)
SCORr26 Load match 2 (S23)
SCORr27 Transmission tracking 2 (S23)
Note: The error terms are channel-specific; they apply to the active calibration of chan-
nel no.
<Chn>
or to the factory calibration (if no channel calibration is active). For the
factory calibration, the query form is allowed only (no change of factory calibration
data).
Tip: Use the generalized command
[SENSe<Ch>:]CORRection:CDATa
to read or
write error terms for arbitrary analyzer ports. For additional programming examples
refer to
Chapter 8.2.5.3, "Saving and Recalling Error Terms" , on page 1236.
CALCulate<Chn>:DATA:STIMulus?
Reads the stimulus values of the active data or memory trace.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Example: See
CALCulate<Chn>:DATA
Usage: Query only
7.3.2.3 CALCulate:DLINe...
The
CALCulate:DLINe...
commands control the horizontal line used to mark and
retrieve response values (display line).
CALCulate<Chn>:DLINe
.................................................................................................689
CALCulate<Chn>:DLINe:STATe
......................................................................................690
CALCulate<Chn>:DLINe <Position>
Defines the position (response value) of the horizontal line.
SCPI Command Reference