Remote Commands for HRP UWB Measurements
R&S
®
VSE-K149
91
User Manual 1179.3315.02 ─ 01
20 GHz
Achieves a higher decimation gain, but reduces the record
length by half.
Only available for R&S oscilloscope models that support a sam-
ple rate of 20
GHz (see data sheet).
For R&S oscilloscopes with an analysis bandwidth of 4
GHz or
larger, a sample rate of 20
GHZ is always used.
*RST:
10 GHz
Default unit: HZ
Example:
INP:RF:CAPM WAV
INP:RF:CAPM:WAVE:SRAT 10000000
Manual operation:
See
INPut<ip>:SELect
<Source>
This command selects the signal source for measurements, i.e. it defines which con-
nector is used to input data to the R&S
VSE.
Suffix:
<ip>
.
1 | 2
For R&S
FSW85 models with two RF input connectors:
1: Input 1 (1
mm [RF Input] connector)
2: Input 2 (1.85
mm [RF2 Input] connector)
For all other models:
irrelevant
Parameters:
<Source>
RF
Radio Frequency ("RF INPUT" connector)
FIQ
I/Q data file
*RST:
RF
Manual operation:
See
"Input Type (Instrument / File)"
INPut<ip>:TYPE
<Input>
The command selects the input path for R&S FSW85 models.
Configuring the Measurement
