Maintenance
Removing and Mounting the System Cover
94
VENICE S | User Manual | 2906.1345.02 - 02
Rohde & Schwarz GmbH & Co. KG
Removing and Mounting the System Cover
Removing the System Cover
Requirements:
Follow the safety guidelines listed in chapter “Safety Instructions”
on page 90 and chapter “Safety” on page 9.
If installed, remove the front plate as described in chapter “Remo-
ving the Front Plate” on page 92.
If applicable, remove the system from the rack.
Perform the following steps:
1.
Rotate the latch release lock counter clockwise to the
unlocked position.
2.
Lift the latch toward the back of the system.
The system cover slides back and the tabs on the system
cover disengage from the slots on the chassis.
The position of the latch may vary depending on the
configuration of your system.