Disabling and Scrapping
R&S
®
TS7124AS
63
Instructions Handbook 1179.2948.02 ─ 01
3. Store the power supply unit for later use.
4. Disconnect all control connections from the chamber.
from the 25-pin D-Sub connector
[X21], cover the open male connector [X21] by its safety cap, see
.
6. Disconnect the earth cable from the chamber's grounding terminal (earth ground
contact ).
To disconnect from compressed air
Proceed as follows:
1. Hold the push-pull adapter at its front ring (1 in
2. Pull the adapter away from the chamber. By doing so, the ring (2) releases the con-
nection with the quick-coupling plug KS3-1/8-A.
At the same time, the adapter is automatically locked by an internal spring-loaded
valve, which prevents losing compressed air.
Figure 11-2: Disconnecting the compressed-air supply
To disconnect the tube from the push-pull adapter
1. Switch off the compressed-air supply.
Otherwise, when you remove the adapter from the tube, your compressed-air sup-
ply system loses pressure.
2. Push the push-pull adapter's blue ring firmly in the direction indicated by the blue
arrows:
Taking Out of Commission
