Self-Test
R&S
®
TS-PSM2
30
User Manual 1178.2773.02 ─ 01
The R&S TS-PSAM analog stimulus and measurement module is used as a measure-
ment unit in the TSVP self-test. The functionality of the modules in the system is
insured by measurements via the analog bus.
The analog bus and the local Powerbus are first tested for not-allowed voltages. These
voltages could possibly come from an outside source, for example through sources
connected to the back. After an isolation measurement between the buses, all relays
(coupling, matrix, local Powerbus, Multiplexer, sense relay) and the shunt resistors are
tested.
For information on starting the self-test and the order of the work steps required as well
as for a detailed description of the tested parameters and procedures, refer to the Ser-
vice Manual R&S CompactTSVP / R&S PowerTSVP.
8.2 Self-Test R&S TS-PRIO
The R&S TS-PRIO module can be detected automatically by the R&S TS-PSM2 mod-
ule plugged in on the front.
For this reason, the module will be shown as a testable module in the TSVP self-test.
When the self-test is performed, the module code will be read and the result written
into the report.
Self-Test R&S TS-PRIO
