Rohde & Schwarz SMM100A, User Manual

Page: 941 / 1088

Remote control commands
R&S
®
SMM100A
941 User Manual 1179.1341.02 ─ 05
See "RF frequency and level display with a downstream instrument" on page 296.
Parameters:
<Power> float
Level at the RF output, without level offset
Range:
See data sheet
Increment: 0.01
Default unit: dBm
Example: SOURce1:POWer:POWer 15
Sets the level at RF output
Manual operation: See "Amplitude" on page 301
See "Used SMM100A Settings For Measurement" on page 403
[:SOURce<hw>]:POWer:STARt <Start>
[:SOURce<hw>]:POWer:STOP <Stop>
Sets the RF start/stop level in sweep mode.
Parameters:
<Stop> float
Sets the setting range calculated as follows:
(Lev OFFSet) to (Lev OFFSet)
Where the values are set with the commands:
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet
[:SOURce<hw>]:POWer:STARt
[:SOURce<hw>]:POWer:STOP
Range: Minimum level to maximum level
*RST: -30 (Start)/ -10 (Stop)
Default unit: dBm
Example: See Example "Setup an RF frequency or power sweep"
on page 950
Manual operation: See "Start Level / Stop Level" on page 343
[:SOURce<hw>]:POWer:STEP:MODE <Mode>
Defines the type of step width to vary the RF output power step-by-step with the com-
mands
POW UP or POW DOWN
.
Parameters:
<Mode> DECimal | USER
DECimal
Increases or decreases the level in steps of ten.
USER
Increases or decreases the level in increments, determined with
the command
[:SOURce<hw>]:POWer:STEP[:INCRement]
.
*RST: DECimal
SOURce subsystem