Rohde & Schwarz SMM100A, User Manual

Page: 856 / 1088

Remote control commands
R&S
®
SMM100A
856 User Manual 1179.1341.02 ─ 05
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal]:DELay <Delay>
Specifies the trigger delay in samples.
Maximum trigger delay and trigger inhibit values depend on the installed options. See
"Specifying delay and inhibit values" on page 101.
Parameters:
<Delay> float
Range:
0 to 2147483647
Increment: 0.01
*RST:
0
Default unit: samples
Example: See "Programming examples" on page 843.
Manual operation: See "(Specified) External Delay/(Specified) Trigger Delay"
on page 112
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal]:INHibit <Inhibit>
Specifies the number of samples, by which a restart is inhibited following an external
trigger event.
Maximum trigger delay and trigger inhibit values depend on the installed options. See
"Specifying delay and inhibit values" on page 101.
Parameters:
<Inhibit> integer
Range:
0 to 21.47 * (clock frequency)
*RST: 0
Default unit: sample
Example: See "Programming examples" on page 843
Manual operation: See "External / Trigger Inhibit" on page 111
[:SOURce<hw>]:BB:MCCW[:TRIGger]:SEQuence <Sequence>
Selects the trigger mode. For detailed description of the trigger modes, refer to "Impact
of the trigger modes on the signal generation" on page 96.
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
*RST:
AUTO
Example: See "Programming examples" on page 843
Manual operation: See "Mode" on page 109
SOURce subsystem