Getting started
R&S
®
SMM100A
56
User Manual 1179.1341.02 ─ 05
To connect the instrument and the external trigger source
1. Use a suitable cable to connect the external trigger source to the User 2 connector
of the R&S
SMM100A. See
.
Figure 3-13: Simplified representation of a test setup**
** = The figure depicts the cabling as a general principle; particular test setups do not require all con-
nections at the same time
The
depicts the location of the connectors and explains the connection
as principle. In practice, you would rather "substitute" the analyzer by a DUT, like a
base station (BS). Other than in the example, the DUT can be the source for the
reference signal. Instead of using an external trigger source, the DUT can also
Trying out the instrument