Rohde & Schwarz SMM100A, User Manual

Page: 510 / 1088

File and data management
R&S
®
SMM100A
510 User Manual 1179.1341.02 ─ 05
Chapter 10.9.1, "Removing file system protection" , on page 510 for description of the
required steps.
This section provides an introduction to the topic. For comprehensive information, refer
to the application note
1GP72: Connectivity of Rohde&Schwarz Signal Generators .
● Removing file system protection ........................................................................... 510
● Accessing the file system of the R&S SMM100A via FTP .................................... 511
● Accessing the R&S SMM100A file system via SMB (Samba) .............................. 512
● Using a USB storage device for file transfer ......................................................... 514
● Using a file server for test files exchange ............................................................. 514
10.9.1 Removing file system protection
Before you try to access the file system via FTP, SMB (samba) or USB, fulfill the follow-
ing:
●
Disable write protection on the file system
●
Enable the corresponding service or interface
To enable write permission on the file system
1. Select "System Config > Setup > Security > Security > General".
2. Select "Disk & Memory".
3. Enable "Volatile Mode".
4. Enter the "Security Password".
The default password is 123456 . For more information, see Chapter 11.5, "Using
the security settings" , on page 562.
The R&S SMM100A requests a reboot.
5. Confirm the request.
The system reboots. The enabled settings are active.
To enable file transfer over FTP
1. Select "System Config > Setup > Security > Security > LAN Services".
2. In the "Common Services" tab, enable "LAN Interface"
3. Enable "FTP"
4. Enter the "Security Password".
The default password is 123456 . For more information, refer to Chapter 11.5,
"Using the security settings" , on page 562.
5. Select "Accept".
To enable file transfer over SMB (samba)
1. Select "System Config > Setup > Security > Security > LAN Services"
How to transfer files from and to the instrument