Rohde & Schwarz SMM100A, User Manual

Page: 300 / 1088

Configuring the RF signal
R&S
®
SMM100A
300 User Manual 1179.1341.02 ─ 05
Access:
► Select "RF" > "RF Frequency" > "Phase".
In the "RF Phase" tab, you can determine the delta phase value and reset the
phase to this reference.
The remote commands required to define the settings are described in Chap-
ter 13.16.15, "SOURce:PHASe subsystem" , on page 933.
Settings
Delta Phase .................................................................................................................300
Reset Delta Phase Display ......................................................................................... 300
Delta Phase
Sets the phase of the RF signal.
The current phase of the signal is used as the reference.
Remote command:
[:SOURce<hw>]:PHASe
on page 933
Reset Delta Phase Display
Adopts the selected "Delta Phase" value as the current value, and resets delta phase
to 0 degrees.
Remote command:
[:SOURce<hw>]:PHASe:REFerence
on page 933
7.7 RF level settings
Access:
1. Select "RF" > "RF Level" > "Level".
RF level settings