Instrument Function
R&S
®
SMF100A
240
Operating Manual 1167.2319.02 ─ 12
Remote command:
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:TRIGger:DTIMe
Auto Set - Power Analysis
Sets the trigger level, the hysteresis and the drop out time to default values.
Remote command:
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:TRIGger:AUTO
Diagram.. - Power Analysis
Returns to the "NRP-Z Analysis Diagram".
Define Markers
Readout and comparison of particular values of the traces is possible by means of four
markers. The markers can be edited either in the diagram or in the "Marker" dialog that
is called with the SETUP key in the "NRP-Z Analysis" diagram.
In the "Marker" dialog, you can activate the marker display ("Visible") and assign a
marker to a certain trace ("Trace"). In the diagram, the exact position must still be
defined.
Markers and the marker list are available in the medium zoom level which is shown in
the graph below. To access the markers, activate the "NRP-Z Analysis (Time, Marker)"
view with the "Rearrange" key. The markers are moved by means of the cursor and the
roll key to the desired trace position. One click activates the marker cursor, the second
click attaches the cursor to the selected marker which now can be moved to the
desired position. Two clicks on the ESC key set the focus back to the diagram. The
positions of the active markers are indicated in the marker list.
Marker - Power Analysis
Selects the marker to be configured.
Remote command:
n.a.
Visible - Power Analysis
Selects if the marker and the marker list are shown in the diagram.
Remote command:
n.a.
Trace - Power Analysis
Selects the trace to which the marker is assigned.
Remote command:
n.a.
RF Level
