Remote Control Commands
R&S
®
SMC100A
302
Operating Manual 1411.4060.32 ─ 04
Parameters:
<Ntransition>
string
Example:
STAT:OPER:NTR 0
A transition from 1 to 0 in the condition part of the Status:Ques-
tionable register does not cause an entry to be made in the EVENt
part.
Usage:
SCPI confirmed
STATus:QUEStionable:PTRansition
<Ptransition>
The command sets the bits of the NTRansition part of the STATus:QUEStionable register.
If a bit is set, a transition from 1 to 0 in the condition part causes an entry to be made in
the EVENt part of the register.
Parameters:
<Ptransition>
string
Example:
STAT:OPER:PTR 32767
All transitions from 0 to 1 in the condition part of the Status:Ques-
tionable register cause an entry to be made in the EVENt part.
Usage:
SCPI confirmed
STATus:QUEue[:NEXT]?
The command queries the oldest entry in the error queue and then deletes it. Positive
error numbers denote device-specific errors, and negative error numbers denote error
messages defined by SCPI. If the error queue is empty, 0 ("No error") is returned. The
command is identical to
SYSTem:ERRor?
Return values:
<NEXT>
string
Example:
STAT:QUE
queries the oldest entry in the error queue.
Response: 0, 'no error'
No errors have occurred since the error queue was last read out.
Usage:
Query only
SCPI confirmed
7.14 SYSTem Subsystem
The
SYSTem
subsystem contains a series of commands for general functions which do
not directly affect signal generation.
...............................................................................................303
....................................................................303
..............................................................304
SYSTem Subsystem
