Rohde & Schwarz SMBV100B, User Manual

Page: 890 / 1030

Remote Control Commands
R&S
®
SMBV100B
888 User Manual 1178.4460.02 ─ 03
You can enable this feature, when you are working with sawtooth shapes in sweep
mode "Single" or "External Single".
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example: See Example "Setup an RF frequency or power sweep"
on page 882.
Manual operation: See "Retrace" on page 329
[:SOURce<hw>]:SWEep:POWer:RUNNing?
[:SOURce<hw>]:SWEep[:FREQuency]:RUNNing?
Queries the current sweep state.
Return values:
<State> 0 | 1 | OFF | ON
Example: See Example "Setup an RF frequency or power sweep"
on page 882.
Usage: Query only
[:SOURce<hw>]:SWEep[:FREQuency]:STEP:LOGarithmic <Logarithmic>
Sets a logarithmically determined step width for the RF frequency sweep. The value is
added at each sweep step to the current frequency.
See Chapter 6.10.2.1, "Correlating Parameters in Sweep Mode" , on page 320.
Parameters:
<Logarithmic> float
The unit is mandatory.
Range:
0.01 to 100
Increment: 1E-3
*RST:
1
Default unit: PCT
Example: See Example "Setup an RF frequency or power sweep"
on page 882.
Manual operation: See " Step Linear/Step Logarithmic " on page 333
[:SOURce<hw>]:SWEep[:FREQuency]:STEP[:LINear] <Linear>
Sets the step width for linear sweeps.
See Chapter 6.10.2.1, "Correlating Parameters in Sweep Mode" , on page 320.
Omit the optional keywords so that the command is SCPI-compliant.
SOURce Subsystem