Rohde & Schwarz SMBV100B, User Manual

Page: 838 / 1030

Remote Control Commands
R&S
®
SMBV100B
836 User Manual 1178.4460.02 ─ 03
Parameters:
<Level> float
Range:
0.02V to 4V
Increment: 1E-4
*RST:
1
Default unit: V
Example: See Example "Enabling and configuring the analog output"
on page 833.
Manual operation: See "I/Q Level Vp EMF" on page 469
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:COUPling[:STATe] <State>
Couples the bias setting of the I and Q signal components.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example: See Example "Enabling and configuring the analog output"
on page 833.
Manual operation: See "Couple I/Q Bias" on page 469
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:I <I>
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:Q <Q>
Specifies the amplifier bias V
bias
of the respective I or Q component.
The value range is adjusted so that the maximum overall output voltage does not
exceed 4V, see
"Maximum overall output voltage" on page 466.
Parameters:
<Q> float
Range:
-3.6V to 3.6V
Increment: 1E-4
*RST:
0
Default unit: V
Example: See Example "Enabling and configuring the analog output"
on page 833.
Manual operation: See "Bias (EMF)" on page 469
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:OFFSet:I <I>
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:OFFSet:Q <Q>
Sets an offset V
offset
between the inverting and non-inverting input of the differential
analog I/Q output signal.
The value range is adjusted so that the maximum overall output voltage does not
exceed 4V, see
"Maximum overall output voltage" on page 466.
SOURce Subsystem