Rohde & Schwarz SMBV100B, User Manual

Page: 727 / 1030

Remote Control Commands
R&S
®
SMBV100B
725 User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:BB:DM:PRAMp[:STATe] <State>
Enables or disables power ramping.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example: See Example "Enable power ramping" on page 714
Manual operation: See "State" on page 127
Trigger Settings
[:SOURce<hw>]:BB:DM[:TRIGger]:SEQuence <Sequence>
Selects the trigger mode. For detailed description of the trigger modes, refer to "Impact
of the Trigger Modes on the Signal Generation" on page 97.
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
*RST:
AUTO
Example: See Example "Adjusting clock, marker and trigger settings"
on page 713
Manual operation: See "Mode" on page 110
[:SOURce<hw>]:BB:DM:TRIGger:SOURce <Source>
Selects the trigger signal source and determines the way the triggering is executed.
Provided are:
●
Internal triggering by a command (
INTernal
)
●
External trigger signal via one of the User x connectors
–
EGT1
: External global trigger
–
EGC1
: External global clock
●
In master-slave mode, the external baseband synchronization signal (
BBSY
)
●
EXTernal
: Setting only
Provided only for backward compatibility with other Rohde & Schwarz signal gener-
ators.
The R&S
SMBV100B accepts this value and maps it automatically as follows:
EXTernal = EGT1
Parameters:
<Source> INTernal|EGT1|EGC1|EXTernal|BBSY
*RST:
INTernal
Example: See Example "Adjusting clock, marker and trigger settings"
on page 713
Manual operation: See "Source" on page 111
SOURce Subsystem