Rohde & Schwarz SMBV100B, User Manual

Page: 445 / 1030

Multi-Instrument Setups
R&S
®
SMBV100B
443 User Manual 1178.4460.02 ─ 03
8.5.1 I/Q Stream Mapper Settings
Access:
► In the block diagram, select "I/Q Stream Mapper".
The dialog provides the settings for routing of the signal streams to the available
output connectors.
Settings:
Frequency Offset .........................................................................................................443
Phase Offset ................................................................................................................443
Map Stream X to Connector ........................................................................................443
Frequency Offset
Sets an absolute frequency offset f
offset
.
Tip: Use this parameter to shift the used frequency band in the RF frequency section
without modifying the RF settings.
Phase Offset
Sets the phase offset of the corresponding stream.
Map Stream X to Connector
The mapping of the generated stream to the output connectors is represented as a
stream matrix. A blue circle at a matrix element routes the stream to the selected con-
nector.
Remote command:
:SCONfiguration:OUTPut:MAPPing:RF:STReam<st>:STATe
on page 665
:SCONfiguration:OUTPut:MAPPing:IQOutput:STReam<st>:STATe
on page 665
8.5.2 External RF and I/Q Settings
With the settings in the "External RF and I/Q" tab, you can control external devices and
instruments from the R&S
SMBV100B, if all prerequisites are fulfilled. See "Prerequi-
sites for control of external instruments from the R&S SMBV100B" on page 444.
System Configuration Settings