Instrument Function
R&S
®
SMBV100A
267
Operating Manual 1407.6062.32 ─ 08
Sets the output voltage for both signal components. Small differences at the inputs can
be taken into account via impairment settings (see
chapter 5.6.1.1, "Impairment Settings
Single ended Output:
●
Value range: 1 mV ... 1.5 V EMF.
Differential Output:
●
Value range: 2 mV ... 3 V EMF.
SCPI command:
Digital Attenuation
The level of the baseband and the RF signal is attenuated by this value.
SCPI command:
Resulting I/Q Level Vp EMF
Displays the resulting output off-load voltage of both signal components at the rear panel.
SCPI command:
5.7 Digital I/Q Output Settings
The output of the
digital baseband signal
requires the option R&S SMBV-K18, Digital
Baseband Connectivity. If this option is connected, the instrument adds as separate
function block to the block diagram, the "BB In/Out" block.
If digital Output is selected, the R&S SMBV displays "DIG I/Q OUT" and a corresponding
symbol in the "BB In/Out" block.
The digital baseband signal is output at a standardized (LVDS) digital I/Q interface.
The settings dialogs for the digital signal output is available in the "BB In/Out" function
block as well as in the menu with the same name which is opened using the MENU key.
To access the settings for the digital I/Q output:
1. select "Block Diagram > BB In/Out > Config... > Baseband Output Settings" or
2. press the MENU key and select "BB In/Out > Baseband Output Settings".
Digital I/Q Output Settings
Summary of Contents for SMBV100A
Page 31: ......
