Rohde & Schwarz SMBV-P101, User Manual, Page: 69 / 131

GNSS Production Configuration and Settings
R&S
®
SMBV-P101
54 User Manual 1176.9787.02 ─ 05
"Current Range without Recalculation"
Displays the dynamic range within which the delay of the marker sig-
nals can be set without restarting the marker and the signal.
Move the setting mark to define the delay.
Remote command:
[:SOURce<hw>]:BB:GNPR:TRIGger:OUTPut<ch>:DELay:MINimum?
on page 105
[:SOURce<hw>]:BB:GNPR:TRIGger:OUTPut<ch>:DELay:MAXimum?
on page 105
"Fix marker delay to current range"
Restricts the marker delay setting range to the dynamic range.
Remote command:
[:SOURce<hw>]:BB:GNPR:TRIGger:OUTPut:DELay:FIXed
on page 105
4.7.3 Clock Settings
Use the provided settings to set the clock source and a delay, if necessary.
Sync. Mode ................................................................................................................... 54
Set Synchronization Settings ........................................................................................ 54
Clock Source .................................................................................................................55
Clock Mode ................................................................................................................... 55
Clock Multiplier ..............................................................................................................55
Measured External Clock .............................................................................................. 55
Sync. Mode
(for R&S SMBV only)
Selects the synchronization mode.
This parameter is used to enable generation of precise synchronous signals of several
connected R&S SMBVs.
Note: If several instruments are connected, the connecting cables from the master
instrument to the slave one and between each two consecutive slave instruments must
have the same length and type. Avoid unnecessary cable length and branching points.
●
"None"
The instrument is working in standalone mode.
●
"Sync. Master"
The instrument provides all connected instruments with its synchronization and ref-
erence clock signal, also including the trigger signal.
●
"Sync. Slave"
The instrument receives the synchronization and reference clock signal from
another instrument working in a master mode.
Remote command:
[:SOURce<hw>]:BB:GNPR:CLOCk:SYNChronization:MODE
on page 107
Set Synchronization Settings
(for R&S SMBV only)
Trigger/Marker/Clock Settings