Rohde & Schwarz SMBV-P101, User Manual, Page: 43 / 131

GNSS Production Configuration and Settings
R&S
®
SMBV-P101
28 User Manual 1176.9787.02 ─ 05
The total power of the generated GNSS signal is displayed with the parameter Total
Power .
Power Mode .................................................................................................................. 28
Reference Power .......................................................................................................... 28
Total Power ................................................................................................................... 28
Power Mode
Indicates that the power calculation is based on user-defined settings.
Remote command:
[:SOURce<hw>]:BB:GNPR:POWer:MODE
on page 80
Reference Power
Sets the power level that is used as a reference for the calculation of the power level of
the satellites.
Remote command:
[:SOURce<hw>]:BB:GNPR:POWer:REFerence[:POWer]
on page 80
Total Power
By enabled signal generation, displays the total power of the generated GNSS signal
at a moment of time. The total power is a real time parameter that follows the real time
changes in the absolute power levels of all active satellites.
Remote command:
[:SOURce<hw>]:BB:GNPR:POWer:TOTal?
on page 81
4.4.2 Configuration of the Satellite Constellation
This section comprises the setting of the satellites constellation and the individual set-
tings of each enabled satellite.
Maximum Number of Satellites ..................................................................................... 28
Constellation Table ....................................................................................................... 28
└ Satellite State ..................................................................................................29
└ Standard ......................................................................................................... 29
└ Signals ............................................................................................................ 29
└ SV-ID/PRN ......................................................................................................29
└ Power ..............................................................................................................29
Maximum Number of Satellites
Displays the number of the 4 satellites that can be simulated.
Remote command:
[:SOURce<hw>]:BB:GNPR:SATellite:COUNt?
on page 71
Constellation Table
Comprises the setting of the satellites constellation.
Satellite Configuration Settings