Rohde & Schwarz SGU100A, User Manual, Page: 158 / 236

Remote Control Commands
R&S
®
SGU100A
156 User Manual 1176.7726.02 ─ 09
:DIAGnostic:POINt:CATalog?
Queries the test points available in the instrument.
For description of the test points, see the service manual.
Example: See Chapter 11.1.1, "Performing General Tasks for Instrument
Setup" , on page 139.
Usage: Query only
:DIAGnostic[:MEASure]:POINt? <Name>
Triggers a voltage or a temperature measurement at the specified test point and
returns the measured value.
Use the command
:DIAGnostic:POINt:CATalog?
to retrieve a list of the available
test points.
For description of the test points, see the service manual.
Query parameters:
<Name> string
Return values:
<Value> number
Default unit: V or °C
Example: See Chapter 11.1.1, "Performing General Tasks for Instrument
Setup" , on page 139.
Usage: Query only
11.8 Fast Speed Commands
This section describes special commands that allow a fast frequency and level setting.
:FFASt
.......................................................................................................................... 156
:PFASt
.......................................................................................................................... 157
:FFASt <Freq>
Special command to set the RF output frequency with minimum latency. No unit (e.g.
Hz) allowed.
Bypasses the status system so command
*OPC?
cannot be appended.
Parameters:
<Freq> float
Example: FFASt 12750000000
Fast Speed Commands