Rohde & Schwarz Scope Rider RTH1002, User Manual

Page: 355 / 530

Remote Control Commands
R&S
®
Scope Rider RTH
355 User Manual 1326.1578.02 ─ 12
Parameters:
<HorizontalStop> Range: 1000 to 500E+6
Increment: 10
*RST:
500E+6
Default unit: Hz
SPECtrum:FREQuency:WINDow:FACTor?
Queries the window factor used for FFT analysis.
Return values:
<WindowFactor> Range: 0.89 to 3.84
Increment: 0.1
*RST:
1.44
Usage: Query only
SPECtrum:FREQuency:WINDow:TYPE <WindowType>
Determines the window function used for FFT analysis. See Table 6-1 for details.
Parameters:
<WindowType> RECTangular | FLATtop | HAMMing | HANN | BLACkman
*RST:
HANN
15.6.2 Spectrum Mode (R&S RTH-K18)
To activate Spectrum mode, use
OP SPEC
(see
OP[:MODE]
on page 298).
The commands described here are specific to the Spectrum mode and require the
R&S
RTH-K18 option to be installed.
In addition, the following commands from the FFT mode (integrated in the base unit)
are also supported:
●
SPECtrum:SOURce
on page 352
●
SPECtrum:FREQuency:HORizontal:SCALe
on page 353
●
SPECtrum:FREQuency:CENTer
on page 353
●
SPECtrum:FREQuency:SPAN[:VALue]
on page 354
●
SPECtrum:FREQuency:WINDow:TYPE
on page 355
●
SPECtrum:FREQuency:MAGNitude:SCALe
on page 353
Commands specific to the Spectrum mode:
● Configuring the Measurement ...............................................................................356
● Cursor Measurements in Spectrum Mode ............................................................ 359
● Markers in Spectrum Mode ...................................................................................362
● Exporting Spectrum Analysis Results ................................................................... 366
Spectrum Analysis