Remote Control
R&S
®
RTM20xx
311
User Manual 1317.4726.02 ─ 01
TRIGger:A:LEVel<n>:RISetime:LOWer
<Level>
TRIGger:A:LEVel<n>:RISetime:UPPer
<Level>
Set the loer and upper voltage threshold, respectively. When the signal crosses these
levels, the slew rate measurement starts or stops depending on the selected polarity.
Suffix:
<n>
.
1..5
The suffix is not relevant, the level applies to all sources.
Parameters:
<Level>
Default unit: V
TRIGger:A:RISetime:SLOPe
<Polarity>
Sets the edge of whic the transition time is to be analyzed:
Parameters:
<Polarity>
POSitive | NEGative
POSitive: rise time trigger
NEGative: Fall time trigger
*RST:
POS
TRIGger:A:RISetime:RANGe
<Range>
Selects how the time limit of the rise or fall time is defined.
Parameters:
<Range>
LONGer | SHORter | WITHin | OUTSide
LONGer | SHORter
Triggers on transition times longer or shorter than the time
WITHin | OUTSide
Triggers on transition times inside or outside the time range TIMe
±
DELTa. Use
*RST:
LONG
TRIGger:A:RISetime:TIME
<RiseTime>
For the ranges LONGer and SHORter, the command defines the minimum and maximum
transition times, respectively.
For the ranges WITHin and OUTSide, the command defines the center of a time range
which is defined using
.
See also:
Parameters:
<RiseTime>
Default unit: s
Command Reference
