Rohde & Schwarz R&S UPP, User Manual

Page: 848 / 938

Remote Control - Command Description
R&S
®
UPP
832 User Manual 1411.1055.32 ─ 10
In all commands for data transmission, the data for both paths is always transmitted
simultaneously.
7.30.2 Load and store setups
In all commands for data transmission, the data for both paths is always transmitted
simultaneously.
●
MMEMory:LOAD:STATe
on page 832
●
MMEMory:STORe:STATe
on page 832
MMEMory:LOAD:STATe <file>
This command loads the specified instrument setting
Loading a setup overwrites the settings of the instrument with the settings that were
active when setup was saved. Depending on the type of setup to be loaded, only the
current settings are overwritten ("current" setup") or the entire settings, including the
position and size of all windows in all screens ("complete" setup). Windows that were
open when the setup was saved are opened, and windows that were closed when the
setup was saved are closed again. This is also done for the screens that are not visi-
ble.
Parameters:
<file> string
file name where the setup was stored by
MMEMory:STORe:STATe
MMEMory:STORe:STATe <file name>
Saving a setup in a 'setupfile'.
Parameters:
<file name> string
Specifies the file name in which the setup is stored. The file
extension defines the type of setup that is stored:
Complete setups are stored if file extension
.set
is used. With
complete setups, the entire instrument settings, plus the position
and size of all windows in all screens is stored.
Current setups are stored if file extension
.sac
is used. With
current setups only the instrument settings are saved. Therefore,
current setups can be loaded much faster, since the panels do
not have to be restored.
Usage: Event
7.30.3 Common MMEMory commands
●
MMEMory:COPY
on page 833
MMEMory Subsystem