Rohde & Schwarz R&S UPP, User Manual

Page: 757 / 938

Remote Control - Command Description
R&S
®
UPP
741 User Manual 1411.1055.32 ─ 10
●
TRACe:WAVeform<n2>:STORe:BY
on page 826
FORMat <format>
Defines the number format for outputting trace data sets.
This setting is not stored in the setup and is set to
ASCII
each time the R&S UPP is
switched on.
Parameters:
<format> REAL | ASCii
REAL
Binary form!
The trace data sets are returned in binary format.
The binary data block has the following structure:
#<lengthofLength><Length><block_data>.
e.g. #234<block_data>
# always introduces the binary block
<lengthofLength> indicates how many positions the following
length specification occupies (2 in example)
<Length> indicates the number of subsequent bytes (34 in
example)
<binary block data> binary block data of specified length
ASCii
Output as an ASCII string, digits with sign, decimal point and
any exponent, e.g.
-57.1647,-6.08881,-32.304,-53.6429 …
DISPlay:BARGraph<n2>:SCANoffset <scanoffset>
DISPlay:FFT<n2>:SCANoffset <scanoffset>
DISPlay:WAVeform<n2>:SCANoffset <scanoffset>
DISPlay:SWEep<n2>:SCANoffset <scanoffset>
Defines the desired scan for outputting trace data sets.
Suffix:
<n2>
.
The range of suffix <n2> varies depending on the subsystem,
see
Chapter 7.5.5, "Output of Trace Data Sets" , on page 738
Parameters:
<scanoffset> 2, 1, 0, -1 to -19
2
max scan
1
min scan
0
latest scan
-1 bis -19
the more negative the number, the older the scan.
Triggering Measurements and Reading Results