Rohde & Schwarz R&S UPP, User Manual

Page: 575 / 938

Instrument Functions
R&S
®
UPP
559 User Manual 1411.1055.32 ─ 10
"3 dig. / 0.1 dB, 4 dig. / 0.01 dB, 5 dig. / 0.001 dB, 6 dig. / 0.0001 dB, 7 dig. /
0.00001 dB"
Significance of the parameter list using an example:
5 dig. / 0.001 dB
5 dig.:
Values which are displayed with a linear unit (V, Hz, etc) are output
with 5 digits:
0.001 dB :
Values which are displayed with a logarithmic unit (dBV, dBu, etc.)
are output to three decimal places:
If the numeric values can no longer be displayed with the selected
resolution, they are rounded off and shown as an exponent:
Scan
This is a display for the current scan and an opportunity to select a scan in the graphi-
cal display. For those graphic systems that allow multiscan recording (Sweep Graph 1
to 4), the desired scan can be selected here. Number 0 means the most recent scan.
The lower the negative number, the older the scan.
Scans identified as Min and Max are available to all graphic systems, provided they are
enabled by
checking the box.
When you use the [Next Scan ] toggle key to scroll through the scans, the current
value is entered here.
Available in the graphics subsystems
Sweep, FFT, Waveform, Bar Graph
Remote command:
DISPlay:SWEep<n2>:SCANoffset
on page 741
Curve, Spectrum and Bar Graph Display