Rohde & Schwarz R&S UPP, User Manual

Page: 559 / 938

Instrument Functions
R&S
®
UPP
543 User Manual 1411.1055.32 ─ 10
Although a single limit curve may be symmetrically shifted it is not very meaningful,
and would be better done using the "Parallel" parameter field.
The limit curves that are separated by 40 dBV, such as after loading a file, are in each
case to be shifted by 10 dBV
and their signs are to be reversed. This produces a symmetrical shift in both curves.
Following the symmetrical shift, the two curves have a separation of only 20 dBV.
Available in the graphics subsystems
Sweep, FFT, Waveform, Bar Graph
Remote command:
DISPlay:SWEep<n2>:A:LIMShift:SYMMetrical
on page 793
DISPlay:SWEep<n2>:B:LIMShift:SYMMetrical
on page 793
New scan
This parameter field appears only for graphic systems that allow multiscans ("Scan" =
"Multi"), and is therefore only available for Sweep Graph 1 to 4 graphic systems.
Available in the graphics subsystems
Sweep
"Replace" means that a selected scan of the current trace will be replaced.
"Append" means that a selected scan will be appended to the current trace.
Here it is irrelevant whether the scan originates from a measurement or is imported
from a trace file specified in the "Import from" parameter field below.
See Chapter 5.51, "Measured value Sequences" , on page 601).
Curve, Spectrum and Bar Graph Display