Rohde & Schwarz R&S UPP, User Manual

Page: 617 / 938

Instrument Functions
R&S
®
UPP
601 User Manual 1411.1055.32 ─ 10
A red measured value and bar indicate that there is a limit violation:
A red measured value in the numeric display also indicates a current limit violation:
In order to indicate that the lower or upper limit was violated in the past, the lower or
upper limit is displayed in red until the [START] key is pressed, which resets the hold
function and restarts monitoring of the measured values:
This hold function is not visible in the numeric display.
5.51 Measured value Sequences
Measured value sequences consisting of acquired function measurement results,
sweeps, FFT data, Waveform data, or Bar Graph data can be stored in a file for differ-
ent purposes:
●
To load the measured values again as a report, to permit comparison or to allow
processing at a later stage. When loaded using commands in the display panel, the
series of measured values are initially displayed exactly as they were when saved.
They can, however, be rescaled or, for example, converted into different units.
●
The files are stored in ASCII format so that they can be easily imported into other
programs where the data can be processed further (e.g. Microsoft Excel). See sec-
tion
Chapter 5.54, "Format" , on page 613 for information on the ASCII format and
how data can be imported into other programs.
Measured value Sequences