Rohde & Schwarz R&S UPP, User Manual

Page: 483 / 938

Instrument Functions
R&S
®
UPP
467 User Manual 1411.1055.32 ─ 10
Here, there is an overview of the filters which can be set up in the analyzer and gener-
ator, together with the remote-control parameters, see
Chapter 5.39.4, "Filter Table" ,
on page 468.
5.39.1 Analyzer Prefilter
A filter which influences all measurement functions can be selected in the Analyzer
Config panel. One of the user-definable filters in the Filter Panel or a weighting filter
can be selected. This means that prefiltering is possible without having to select the
required filter for every single measurement function.
Remote command:
INPut:FILTer, on page 773
5.39.2 Analyzer Function Filters
In the Analyzer Function panel, up to 2 of the user-definable filters in the Filter panel or
weighting filters can be looped into the measurement path regardless of which level
measurement method is selected.
5.39.3 Generator Filters
Most of the generator signals can be filtered in the time domain. A user-defined filter, a
weighting filter, or a highpass or lowpass filter can be selected in the Function panel.
Remote command:
SOURce:FILTer
on page 776
If a filter with gain is used (such as the "CCIR 1k wtd" weighting filter), the generator
signal level must be selected as described below in such a way that overranging can-
not occur with the maximum filter gain.
Filter