Rohde & Schwarz R&S RTM-B1, User Manual

Page: 467 / 854

Remote Control Commands
R&S
®
RTM3000
467 User Manual 1335.9090.02 ─ 08
To set the range ± Δt, use
TRIGger:A:RUNT:DELTa
.
Parameters:
<Range> LONGer | SHORter | WITHin | OUTSide
LONGer
Finds pulses longer than the given width.
SHORter
Finds pulses shorter than the given width.
WITHin
Finds pulses inside the range width ± Δt .
OUTSide
Finds pulses outside the range width ± Δt .
*RST: LONG
TRIGger:A:RUNT:WIDTh <Width>
Sets the reference runt pulse width, the nominal value for comparisons.
Parameters:
<Width> Range: Depends on various settings, mainly time base and
sample rate
16.5.8 Risetime Trigger
TRIGger:A:LEVel<n>:RISetime:LOWer
............................................................................ 467
TRIGger:A:LEVel<n>:RISetime:UPPer
............................................................................. 467
TRIGger:A:RISetime:DELTa
............................................................................................ 468
TRIGger:A:RISetime:RANGe
.......................................................................................... 468
TRIGger:A:RISetime:SLOPe
........................................................................................... 468
TRIGger:A:RISetime:TIME
..............................................................................................468
TRIGger:A:LEVel<n>:RISetime:LOWer <Level>
Sets the lower voltage threshold. When the signal crosses this level, the rise time mea-
surement starts or stops depending on the selected slope.
Suffix:
<n>
.
1..5
Parameters:
<Level>
TRIGger:A:LEVel<n>:RISetime:UPPer <Level>
Sets the upper voltage threshold. When the signal crosses this level, the rise/fall time
measurement starts or stops depending on the selected slope.
Suffix:
<n>
.
1..5
Trigger
www.allice.de Allice Messtechnik GmbH