Rohde & Schwarz R&S FPH, User Manual

Page: 351 / 484

Remote Commands
R&S ® Spectrum Rider FPH
346 User Manual 1321.1011.02 ─ 06.00
●
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel[:RELative]
on page 346
●
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel[:RELative]:
STATe
on page 347
●
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel:ABSolute
on page 347
●
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel:ABSolute[:
STATe]
on page 347
●
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel:RESult?
on page 348
●
CALCulate<1...2>:LIMit<1...2>:ACPower:ALTernate<1...11>[:
RELative]
on page 348
●
CALCulate<1...2>:LIMit<1...2>:ACPower:ALTernate<1...11>[:
RELative]:STATe
on page 349
●
CALCulate<1...2>:LIMit<1...2>:ACPower:ALTernate<1...11>:
ABSolute
on page 349
●
CALCulate<1...2>:LIMit<1...2>:ACPower:ALTernate<1...11>:
ABSolute[:STATe]
on page 349
●
CALCulate<1...2>:LIMit<1...2>:ACPower:ALTernate<1...11>:
RESult?
on page 350
CALCulate<1...2>:LIMit<1...2>:ACPower:STATe <State>
This command turns the limit check for ACLR measurements on and off.
You have to use
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel[:
RELative]:STATe
on page 347 or
CALCulate<1...2>:LIMit<1...2>:
ACPower:ALTernate<1...11>[:RELative]:STATe
on page 349 in combination
with this command to select the channels the limit check should be performed on.
The suffix at CALCulate and LIMit are irrelevant for this command.
Parameters:
<State> ON | OFF
*RST:
OFF
Example:
CALC:LIM:ACP ON
Activates the limit check.
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel[:RELative] <RelativeLimit>
This command defines the relative limit of the adjacent channels. The reference value
for the relative limit value is the measured channel power.
Note that the relative limit has no effect on the limit check if it is below the absolute limit
value (see
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel:ABSolute
on page 347. This mechanism allows automatic checking of the absolute basic values
of adjacent-channel power as defined in mobile radio standards.
Remote Control - Commands