Operation
R&S
®
ATS1000
53
Instructions Handbook 1179.2983.02 ─ 01
This holder can carry a printed circuit board (PCB) in addition to your DUT, for example
if your setup requires a separate PCB inside the chamber for signal conditioning. Place
your DUT on top of the DUT holder, and place your signal conditioning PCB on the
PCB holder set.
Prerequisites for using the PCB holder set:
●
has assembled the PCB holder.
●
has fixed the PCB on the PCB holder by clamping claws and
screws (labeled 5 to 7 in
●
has fixed the DUT holder's metal base plate (8) on the turntable (9).
●
has fixed the PCB holder below the base plate, considering the
position of the turntable's crank (
).
●
has threaded all cables required for connecting the DUT from the
PCB holder close to the DUT's position.
Figure 7-8: Holder set for carrying a printed circuit board (PCB) in addition to a DUT
1 = Mounting plate
2 = Mounting bracket
3 = Assembly screws (M3 x 12 mm)
3a = Centered assembly holes
3b = Lateral assembly holes
4 = 2 mounting screws (M3 x 7 mm)
5 = Clamping claws
6 = Short clamping screws (M3 x 12 mm)
7 = Long clamping screws (M3 x 25 mm)
8 = Metal base plate of a polymer DUT holder set (labeled 5 in
9 = Telescopic tube of the turntable's lifting mechanism (labeled 2 in
Placing a DUT in the Chamber
