Rohde & Schwarz OSP-B200S2, User Manual

Page: 74 / 327

Modules
R&S
®
OSP
74 User Manual 1178.7100.02 ─ 05
Figure 3-29: Dialog for configuring the delay times of the external relays
Enter delay values to set the delay times, or click the "-/+" buttons to decrease or
increase the delay values in steps of 1. A delay value of 1 is equivalent with a com-
mand delay time of 50
ms. Hence, you can set the delay times in multiples of 50 ms.
The default delay value of 2 is equivalent with 100 ms.
The range of allowable delay values is 0 to 19, equivalent with delay times ranging
from 0
ms to 950 ms.
For further information on command delay times for transfer relays connected to the
R&S
OSP-B104, refer to
CONFigure:RELay:DELay
on page 269.
For operation, see Chapter 4, "Operation" , on page 147 and Chapter 5, "Functions" ,
on page 155.
For remote control, refer to the chapters Remote Operation and RC Commands . For
an example, see
ROUTe:CLOSe
on page 253.
3.12 R&S OSP-B106 RF Switch Module
Figure 3-30: R&S OSP-B106
Lower row = 3 SPDT relays K1 to K3 with N connectors
Upper row = 3 SPDT relays K4 to K6 with BNC connectors
R&S OSP-B106 RF Switch Module