Rohde & Schwarz OSP-B200S2, User Manual

Page: 59 / 327

Modules
R&S
®
OSP
59 User Manual 1178.7100.02 ─ 05
The relays are mounted directly into the module's panel and soldered to the module's
printed board, to avoid relay cabling and allow a compact module size.
The switch unit provides power supply and control via a single module bus cable to a
module bus connector on the module's printed board. The module's on-board memory
stores its configuration data.
Figure 3-5: Pinout and block diagram of RF switch module R&S OSP-BM6x (here with 3 SPDT relays)
Figure 3-6: Representation of the module on the control screen (left: 1 SPDT, right: 3 SPDT)
For operation, see Chapter 4, "Operation" , on page 147 and Chapter 5, "Functions" ,
on page 155.
For remote control, refer to the chapters Remote Operation and RC Commands . For
an example, see
ROUTe:CLOSe
on page 253.
3.3 R&S OSP-BM6xE RF Switch Module
Figure 3-7: R&S OSP-BM6xE (here with 1 SP6T + 3 SPDT relays)
R&S OSP-BM6xE RF Switch Module