Functions
R&S
®
OSP
213
User Manual 1178.7100.02 ─ 05
More
To get more options for handling a secondary switch unit, click the "More" button (dots
icon) . When you click this button in the line of an existing secondary switch unit, the
following option buttons are shown for this switch unit:
Figure 5-50: The More button (dots icon) gives access to the option buttons of a secondary switch
unit
To hide the option buttons without further action, click the secondary switch unit's entry
at its left-hand side, outside of the option buttons.
Note:
You cannot edit the first frame (with frame ID
F01
), which is the primary switch
unit. Other than in
, the primary switch unit only has the
button:
This button allows adding a secondary switch unit, as described below.
Move Up / Move Down
The "Move Up" and "Move Down" buttons move the entry of this secondary switch unit
1 position up or down in the list. After moving an entry, the option buttons are still avail-
able, to facilitate repeated moving actions.
If an entry is in the top line, you cannot move it further up, and the "Move Up" button is
not available. If an entry is in the lowest line, you cannot move it further down, and the
"Move Down" button is not available.
Note:
The frame IDs are locked to the positions in the list. When you move a secon-
dary switch unit to a different position, it exchanges the frame ID with the displaced
secondary switch unit. Hence, for example, the second entry in the list (which is the
first secondary switch unit) always has frame ID
F02
.
Before moving secondary switch units, consider that a change of frame IDs disturbs
existing path definitions that refer to these secondary switch units.
Add Secondary
The button with the plus icon enters a line for a new secondary switch unit in the list of
frames.
●
If you click the button "Add a secondary decice:" at the end of the list, the new sec-
ondary switch unit is added below the existing entries without displacing existing
secondary switch units.
●
If you click "Add Secondary" in the line of the primary switch unit or any existing
secondary switch unit, the new secondary device is added immediately below that
line.
Configuration
