Rohde & Schwarz NRPM OTA Power Measurement Solution, Manual

Page: 17 / 229

Preparing for use
R&S
®
NRPM
17 Mannual 1425.8663.02 ─ 08
4 Preparing for use
Here, you can find basic information about setting up the product for the first time.
● Unpacking and checking ................................................................................. 17
● Choosing the operating site ............................................................................ 17
● Considerations for test setup .......................................................................... 18
● Powering the R&S NRPM3(N) sensor module ................................................20
● Hardware and software requirements ............................................................. 20
● Installing the software application and drivers ................................................ 23
4.1 Unpacking and checking
1. Unpack the product carefully.
2. Retain the original packing material. Use it when transporting or shipping the
product later.
3. Using the delivery notes, check the equipment for completeness.
4. Check the equipment for damage.
If the delivery is incomplete or equipment is damaged, contact
Rohde
& Schwarz.
4.2 Choosing the operating site
Specific operating conditions ensure proper operation and avoid damage to the
product and connected devices. For information on environmental conditions
such as ambient temperature and humidity, see the data sheet.
Electromagnetic compatibility classes
The electromagnetic compatibility (EMC) class indicates where you can operate
the product. The EMC class of the product is given in the data sheet.
●
Class B equipment is suitable for use in:
– Residential environments
Choosing the operating site