Rohde & Schwarz NRPM OTA Power Measurement Solution, Manual

Page: 139 / 229

Remote control commands
R&S
®
NRPM
139 Mannual 1425.8663.02 ─ 08
Trigger sources
The possible trigger conditions and the execution of a trigger depend on the
selected trigger source.
If the signal power exceeds or falls below a reference level set by the trigger
level, the measurement starts after the defined delay time. Waiting for a trigger
event can be skipped by selecting
TRIGger:IMMediate
.
Trigger
source
Description Remote commands to initiate the
measurement unconditionally
Hold Triggered by the remote command.
TRIGger:IMMediate
Immediate Measures immediately, does not
wait for trigger condition.
-
Internal Uses the input signal as trigger sig-
nal.
TRIGger:IMMediate
External 1 Uses the digital input signal sup-
plied using a differential pair in the
8-pin sensor module cable.
TRIGger:IMMediate
External 2 Uses the digital input signal sup-
plied at the SMB connector.
TRIGger:IMMediate
Bus Triggered by the remote command.
*TRG
TRIGger:IMMediate
Dropout time
The dropout time is useful when dealing with signal with several active slots, for
example GSM signals, as, e.g., shown in
Figure 10-1 . When measuring in sync
with the signal, a trigger event is to be produced at A, but not at B or C.
Controlling the measurement