Rohde & Schwarz NRP T Series, User Manual

Page: 124 / 169

Remote Control Commands
R&S
®
NRPxxT(N)
124 User Manual 1177.6023.02 ─ 08
The sensor name that you specify here is independent from the hostname of the sen-
sor. However, if the sensor name is not specified, it defaults to the hostname.
Example:
SYST:NAME "InputModule-X5"
Results in a display as shown in Figure 9-7 .
Figure 9-7: Sensor Name
Parameters:
<sensorname>
Manual operation: See "Sensor Name" on page 52
SYSTem:VERSion?
Queries the SCPI version that the command set of the sensor complies with.
Example: SYST:VERS?
Query
1999.0
Response: SCPI version from 1999.
Usage: Query only
9.12 Using the Status Register
Further information:
●
Chapter 11.3, "Status Reporting System" , on page 142
Contents:
● General Status Register Commands .................................................................... 125
● Reading Out the CONDition Part .......................................................................... 125
● Reading Out the EVENt Part .................................................................................125
● Controlling the ENABle Part ..................................................................................126
● Controlling the Negative Transition Part ............................................................... 126
● Controlling the Positive Transition Part ................................................................. 127
Using the Status Register