Preparing for use
R&S
®
HMP Series
24
Getting Started 1178.6791.02 ─ 03
4. Plug the AC power cable into a power outlet with ground contact.
Do not use a cheater plug or other means to bypass or disconnect the protec-
tive ground lead.
The required ratings are listed on the front panel of the R&S
HMP, see
4.8
Connecting to LAN
Option: R&S
HO732 dual Ethernet / USB interface
Equipped with the interface, the R&S
HMP provides Ethernet (LAN) connectivity.
If you have assigned the corresponding rights, you can use this interface for
remote control and data transfer from a controller PC. Make sure that you have
connected the controller PC in the same network.
Consult your network administrator before performing the following tasks to avoid
a network failure:
●
Connecting the instrument to the network
●
Configuring the network
●
Changing IP addresses
For remote control over other interfaces, refer to the description in chapter "Net-
work and remote control operation" in the user manual of the R&S
HMP.
To operate securely
1.
NOTICE!
The R&S
HMP is designed to operate at local workplaces or in
secured networks (LAN).
When connected to the LAN, the R&S
HMP can potentially be accessed from
the internet, which constitutes a security risk. For example, attackers can mis-
use or damage your device.
Use secured connections for internet or remote access, if applicable.
2. Ensure that the network settings comply with the security policies of your com-
pany. Contact your local system administrator or IT department before con-
necting your product to your company LAN.
3. Always install the latest firmware.
Connecting to LAN