Subject to change without notice
P r o b e H Z O 3 0
General
Operating Basics
When using this active probe device make sure the
measuring instrument is set to 50 Ω input coupling
and the probe is connected to the power supply.
In order to get best measurement results please
make sure that the power cord does have the
maximum possible distance to the probe tip.
Handling
Note that the probe cable is a sensitive part of the
probe. Do not damage through excessive bending
or pulling. Avoid mechanical shock to this product
in general to guarantee accurate performance
and protection.
Cleaning
To clean the exterior of the probe use a soft
cloth moistened with either distillated water or
isopropyl alcohol. Before use allow the probe to
dry completely.
Warranty and repair
HAMEG instruments are subjected to a strict qua-
lity control. Prior to leaving the factory, each in-
strument is burnt-in for 10 hours. By intermittent
operation during this period almost all defects are
detected. Following the burn-in, each instrument
is tested for function and quality, the specifications
are checked in all operating modes; the test gear
is calibrated to national standards.
The warranty standards applicable are those of
the country in which the instrument was sold.
Reclamations should be directed to the dealer.
Only valid in EU countries
In order to speed reclamations customers in EU
countries may also contact HAMEG directly. Also,
after the warranty expired, the HAMEG service will
be at your disposal for any repairs.
Return material authorization (RMA):
Prior to returning an instrument to HAMEG ask
for a RMA number either by internet (http://www.
hameg.com) or fax. If you do not have an original
shipping carton, you may obtain one by calling the
HAMEG service dept (++49 (0) 6182 800 500) or by
sending an email to [email protected].
