Remote Commands
R&S
®
FSW
986
User Manual 1173.9411.02 ─ 19
Manual operation:
See
CALCulate:LIMit<k>:STATe
<State>
This command turns the limit check for a specific limit line on and off.
To query the limit check result, use
.
Note that a new command exists to activate the limit check and define the trace to be
checked in one step (see
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALC:LIM:STAT ON
Switches on the limit check for limit line 1.
Usage:
SCPI confirmed
Manual operation:
See
CALCulate:LIMit<k>:TRACe<t>:CHECk
<State>
This command turns the limit check for a specific trace on and off.
To query the limit check result, use
.
Note that this command replaces the two commands from previous signal and spec-
trum analyzers (which are still supported, however):
●
●
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALC:LIM3:TRAC2:CHEC ON
Switches on the limit check for limit line 3 on trace 2.
Manual operation:
See
Checking the Results of a Limit Check
CALCulate:LIMit:CLEar[:IMMediate]
.................................................................................986
..............................................................................................987
CALCulate:LIMit:CLEar[:IMMediate]
This command deletes the result of the current limit check.
The command works on all limit lines in all measurement windows at the same time.
Analyzing Measurements (Basics)
